Dabbling at DIY: fixing dripping taps and wiring bathroom extractor fans

This content is 9 years old. I don't routinely update old blog posts as they are only intended to represent a view at a particular point in time. Please be warned that the information here may be out of date.

This week, my blog is in danger of transforming from markwilson.it to markwilson.diy. Fear not, normal service will be resumed soon!

As I’ve worked through the seemingly never-ending list of jobs-that-need-to-be-done-one-day this week, I dabbled in some minor plumbing and electrical work… I thought I’d blog some notes because I’m bound to have to come back to this again one day!

Changing the ceramic valve in a dripping tap

The Franke Panto taps that were installed in our kitchen/utility room have been great – after all, their function is pretty straightforward: all I want a tap to do is look good and dispense water on demand!

Unfortunately the kitchen tap had begun to drip on the cold flow. A mini science experiment with my sons told me it was losing quite a lot of water every day so I turned off the cold supply using the isolator valve below the sink. I couldn’t see how to fix the tap though, so we asked advice from a plumber we’ve worked with before. He didn’t know how to get into the tap but told us it would be the ceramic valve that needed replacing (cue sucking of air through teeth and “it’ll cost you” look) and we might as well get a new tap.

What nonsense! After 3 months of confusion about which part to buy based on my Internet “reaseach” and putting off calling Franke’s spares/service partners for fear of being bamboozled, Central Services were really helpful, a new ceramic valve cost me just over £15 and I installed it myself in 5 minutes…

One of the challenges I had was whereas it seems for many taps you can prise away the cap on the end of the tap (the bit with the red or blue marker on it), ours didn’t work like that as the Panto just has a tiny marker on the front of the tap to show which side is hot/cold. Then I realised that there was a cap on the end – it was on a screw thread, which then exposed the grub screw inside, allowing access to the valve, which was then easily removed with a spanner (after removing the collar that covers it).

Of course, after I had asked a plumber, procrastinated, and finally done the job myself I found this video (ignore the sexist comments if you view it on YouTube…):

Blue and yellow wires for live and neutral?

Another job was to change the old, noisy, bathroom fan for something quieter as part of my preparation for an upcoming bathroom refit. When I took the old one out I was surprised to find that the wiring used red/yellow/blue (what appears to be three-phase wiring) instead of twin and earth.

(My house was built in the 1990s – today the red/yellow/blue would be brown/black/grey.)

I could see that blue was neutral and yellow was live (based on how the old fan was wired) but couldn’t understand why until I found this advice on installing a shower extractor fan. Yellow (now black) is switched live (cf. red/brown for live, not used in my installation).

 

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.